Description
I designed this lightbar in September 2025 and have been using it ever since.
You will receive just the mount and the hardware (bolts). To install, you open the front trunk, remove the plastic cover with a socket, find the 48v feed on the left side, and then wire the lightbar to a voltage converter and then wire that to the truck. You then control it from the main touch screen by going to “outlets” and turning on the front feed. You must provide your own light bar. It is designed to work with the 42″ version of this: https://amzn.to/427Wkle
Note that the Cybertruck is 48 volt DC, and this light bar required 12-24 volts. That means you also must buy a 48v to lower voltage DC to DC converter. They are typically under $30 on Amazon. Optionally you may want a DT 2-Pin Automotive connector to plug into the light bar instead of cutting the connector off it – such as this: https://amzn.to/42bQW0k
You need to be handy as I cannot provide install help.
Cybertruck, Lightbar, and DC converter not included. Printed from high-temperature ABS in a heated chamber (Bambu H2D). I have run a print farm since 2019 and have made over 14,000 parts since then (mostly of medical devices).
